共找到 150 條與 側(cè)向速度 相關的標準，共 10 頁
Equipment for radial acceleration dispersal. General requirements
Wheel chairs.Part 6: Determination of maximum speed, acceleration and deceleration of electric wheelchairs
This standard specifies test methods for determining the maximum speed, acceleration and deceleration of electrically powered wheelchairs including
Wheelchairs - Part 6: Determination of maximum speed, acceleration and deceleration of electric wheelchairs
Sets out a terminology for describing the repair and servicing of constant velocity joints used in automotive vehicles
Automotive repairs - Terminology - Constant velocity joints
This National Standard of Canada is equivalent to International Standard ISO 7176-6:1988. 1. Scope 1.1 The purpose of this Standard is to provide
Wheelchairs - Determination of Maximum Speed, Acceleration, and Retardation of Electric Wheelchairs
Wheelchairs - Part 6: Determination of Maximum Speed, Acceleration and Deceleration of Electric Wheelchairs
The results from this test method are used to calibrate aggregate spreaders and verify the uniformity of distribution transversely prior
Standard Test Method for Determining the Transverse-Aggregate Spread Rate for Surface Treatment Applications
Use of short flat vanes for producing efficient wide-angle two-dimensional subsonic diffusers
? ??? 15 km/h(4.167 m/s)? ???? ?? ?? ??? ??? ? ???
Wheelchairs-Part 6:Determination of maximum speed, acceleration and deceleration of electric wheelchairs
Steering Column Stiffness (English/German; This specification may be applied only for current projects incl. Global Epsilon e (37##). It is Superceded for all future projects and replaced by GMW14216.)
This standard applies to agitator drives according to DIN 28130 part 3 and specifies the following data: agitator speed and direction, bearing
Requirements on agitator drives - Agitator speed and direction, bearing application running accuracy, dis-mounting space for shaft seal
Requirements on agitator drives - Agitator speed and direction, bearing application running accuracy, dis-mounting space for shaft seal
Textiles - Behavior in fire - Determination of flame propagation properties on test pieces oriented at 45 degrees - Measurement of flame propagation speed
ESDU 71006 presents the normal and axial force coefficients@ the pitching moment coefficient and the position of the aerodynamic centre of uncambered
Low-speed longitudinal aerodynamic characteristics of slender wings.
Wheelchairs. Part 6 : determination of maximum speed, acceleration and retardation of electric wheelchairs.
