共找到 150 條與 切割直徑 相關的標準，共 10 頁
Reamers. Special tolerances for cutting diameter.
Round punches with straight shaft up to 20 mm cutting diameter
Round punches with stepped shaft up to 5,5 mm cutting diameter
Round punches with stepped shaft up to 5,5 mm cutting diameter
Round punches with straight shaft up to 20 mm cutting diameter
Round punches with steped shaft up to 5,5 mm cutting diameter are mainly used for the manufacture of small and medium size workpieces
Round punches with stepped shaft up to 5,5 mm cutting diameter
Round punches with stepped shaft up to 5,5 mm cutting diameter
Round punches with straight shaft up to 20 mm cutting diameter
本標準規定了型材切割機的分類技術要求、試驗方法、檢驗規則、標志、包裝、運輸、貯存。 本標準適用于以三相或單相異步電動機為動力的，用纖維增強樹脂砂輪片切割鋼型材的機械
Formed steel cutter
本標準規定了型材切割機的基本參數和型式、技術要求、試驗方法、檢驗規則、標志和包裝、保修期限和附件。本標準適用于一般環境條件下,用纖維增強樹脂薄片砂輪對圓形鋼管、異型鋼管、鑄鐵管、圓鋼、角鋼、槽鋼、扁鋼等型材進行切割,并以三相工頻、單相電容電動機或單相串勵電動機為動力的可移式型材切割機(以下簡稱切割機
Cut-off machines
本文件規定了粒度切割器切割性能測試方法中的通用定義和要求。本文件適用于空氣顆粒物采樣用粒度切割器（以下簡稱“切割器"）切割性能的測試
Particle size cutter cutting performance test Part 1: General
本文件規定了無電切割設備的術語和定義、構成及原理、要求、試驗方法、檢驗規則、標識、包裝、運輸及貯存。 本文件適用于無電切割設備的生產及檢驗
Electric Cutting Equipment
PRIEMERY V?LCOV?CH STOPIEK REZN?CH N?STROJOV Diameters of taper shanks of cutting tools Schválenie ST SEV 151-89 odporu?ilo Federálně ministerstvo
Diameters of cutting tool taper shanks
Numbering System for Multiple Diameter Cutting Tools
Numbering System for Multiple Diameter Cutting Tools
