共找到 150 條與 單個氣缸排量 相關的標準，共 10 頁
Copper indirect cylinders for domestic purposes. Single feed indirect cylinders
Gas cylinders. Valve outlets
本標準規定了最高工作壓力1 MPa、缸徑為8 mm 至25 mm 單桿氣缸的安裝尺寸,以滿足產品互換性的要求。 注:本標準僅提供基本的指導方針,允許制造商自行設計氣缸,不限制技術開發
Pneumatic fluid power—Single rod cylinders,bores from 8 mm to 25 mm—Mounting dimensions
Scope is not provided for this standard
Pneumatic fluid power -- Cylinders -- Single-rod short-stroke cylinders, 1 000 kPa (10 bar) series, bores from 20 mm to 100 mm
本標準適用于最高使用壓力為1000kPa、缸內徑為8～25mm的單桿氣缸
Pneumatic fluid power--Single rod cylinders--Bores from 8 to 25mm--Mounting dimensions
本標準規定了最高工作壓力為1MPa、缸內徑8mm～25mm的單桿氣缸的安裝尺寸，從而達到產品互換性的要求
Single rod air cylinders, bores from 8mm to 25mm.Mounting dimensions
Shipbuilding. Internal scuppers. Single scuppers.
本標準適用于最高工作壓力1.0 MPa、缸內徑32～250 mm的單桿氣缸
The installation size of integral single-rod cylinder with cylinder inner diameter of 32~250mm
本標準規定了可拆式單桿氣缸的安裝尺寸。 本標準適用于最高使用壓力為1MPa、缸內徑為32～320mm可拆式單桿氣缸
Installation dimensions of detachable single-rod cylinder with cylinder inner diameter of 32-320mm
Pneumatic fluid power－Single rod cylinders－10 bar(1 000 kPa) series－Bores from 8 to 25 mm－Mounting dimensions
Specifies interchangeability dimensions for four mounting styles of cylinder with bores in the range 8 mm to 25 mm
Mounting dimensions of single rod double acting 10 bar pneumatic cylinders-Specification for cylinders up to 25 mm bore
Calculations of GHG emissions throughout the LNG chain
? ??? ????? ???? ?? ?? ?? 1 000 kPa(10 bar)? ?? ??
Pneumatic fluid power-Single rod cylinders-10 bar(1 000 kPa) series-Bores from 8 to 25 mm-Mounting dimensions
This International Standard establishes a metric series of mounting dimensions required for interchangeability of commonly used pneumatic cylinders
Pneumatic fluid power. Single rod cylinders. 10 bar (1 100 kPa) series. Bores from 8 to 25 mm. Mounting dimensions
Calculations of GHG emissions throughout the LNG chain
