WJ/Z 384-1995 火箭彈強力旋壓加工時間定額

Processing time quota for powerful spinning of rockets

AWWA ACE56141 保持 WaterOne 的壓力

WaterOne has mitigated a problem common to large distribution systems that have outgrown their initial floating storage and have changed

Keeping the Pressure at WaterOne

GOST 9625-1987 層壓膠合板.靜力彎曲時強度和彈性模數的測定方法

Laminated glued wood. Method for determination of strength and elasticity module in static bending

AS 2313.1.13:2006 單側和雙側壓敏膠粘帶的試驗方法．粘附力．環境溫度下的抗剪強度（保持力）

Specifies a method for determining the low-speed value of the protective release liner from the surface of the adhesive face of pressure-sensitive

Methods of test for single sided and double sided pressure-sensitive adhesive tape - Adhesion - Resistance to shear (holding power) at ambient temperature

ASTM D3653-78 線性和多方向纖維增強壓力敏感帶的保持力測定方法

Method for determining the holding force of linear and multi-directional fiber-reinforced pressure-sensitive tapes

GOST 9625-1972 層壓木 靜態彎曲時拉伸強度和彈性模量的測定方法

Laminated wood. Method for determining the tensile strength and modulus of elasticity during static bending

AGFW FW 442 A:2011-12 壓力穩定在供暖水網絡中的壓力保持

Pressure stabilization Pressure maintenance in heating water networks

ASTM D7012-07e1 壓力和溫度變化狀態下完整巖心試樣的抗壓強度和彈性模量的標準試驗方法

The parameters obtained from these procedures are in terms of undrained total stress (as already mentioned in 1.1.1.). However, there are some

Standard Test Method for Compressive Strength and Elastic Moduli of Intact Rock Core Specimens under Varying States of Stress and Temperatures

AS Z24.10.3:1968 壓敏膠帶測試方法 方法 10.3：保持力 雙面膠帶的保持力

Methods of test for pressure sensitive adhesive tapes, Method 10.3: Holding power - Holding power of double faced tape

ASTM D7012-14e1 壓力和溫度變化狀態下完整巖心試樣的抗壓強度和彈性模量的標準試驗方法

1.1 These four test methods cover the determination of the strength of intact rock core specimens in uniaxial and triaxial compression. Methods

Standard Test Methods for Compressive Strength and Elastic Moduli of Intact Rock Core Specimens under Varying States of Stress and Temperatures

AS Z24.10.2:1968 壓敏膠帶試驗方法 方法 10.2：保持力 遮蔽膠帶的保持力

Methods of test for pressure sensitive adhesive tapes, Method 10.2: Holding power - Holding power of masking tape

AS Z24.10.1:1968 壓敏膠帶試驗方法 方法 10.1：保持力 對標準面板的保持力

Methods of test for pressure sensitive adhesive tapes, Method 10.1: Holding power - Holding power to standard panel

DIVISION I 9.23-1996 應力轉移時的混凝土強度

Concrete Strength at Stress Transfer

AS/NZS 2512.5.1:2008 保護頭盔測試方法.方法5.1:保持系統強度的測定.靜態強度

Methods of testing protective helmets - Determination of strength of retention system - Static strength

ASHRAE 3915-1995 PI 控制風扇速度以保持恒定的排氣壓力

PI Control of Fan Speed to Maintain Constant Discharge Pressure