共找到 150 條與 壓力額定值 相關的標準，共 10 頁
This standard establishes the nominal voltages ratings and operating tolerances for 60-hertz electrical power systems above 100 volts. It also makes
Electric Power Systems and Equipment-Voltage Ratings (60 Hertz)
This International Standard is applicable to screens with height and length greater than 1,5 m. However, it may also be used for smaller screens
Capability of detection - Methodology for comparing the minimum detectable value with a given value
Statistical methods. Capability of detection. Methodology for comparing the minimum detectable value with a given value
This SAE Recommended Practice is intended to serve as areference for the amount of torque that a power take-off caninduce on the transmission mounting
Torque Ratings for Power Take-off Mounting Pads
Zpracovatel: FORM, státní podnik Brno, I?O 129 461, Marian ?trba Pracovník Federálního ú?adu pro normalizaci a mě?ení: Ing. Pavel Dvo?ák
Open front mechanical power presses. Capacity ratings and dimensions
This International Standard specifies capacity ratlngs and dimensions for open front mechanical presses with or without a passage through the frame
Open front mechanical power presses — Capacity rating and dimensions
Open front mechanical power presses. Capacity ratings and dimensions.
Pressure ratings for ferrous material pipe flanges
OPEN FRONT MECHANICAL POWER PRESSES. CAPACITY RATINGS AND DIMENSIONS.
Capability of detection - Part 4 : methodology for comparing the minimum detectable value with a given value.
Capability of detection－Part 4：Methodology for comparing the minimum detectable value with a given value
Capability of detection -- Part 4: Methodology for comparing the minimum detectable value with a given value
This part of ISO 11843 deals with the assessment of the capability of detection of a measurement method without the assumptions in ISO 11843-2
Capability of detection - Part 4: Methodology for comparing the minimum detectable value with a given value
本標準規(guī)定了電壓力鍋的能效等級、能效限定值和試驗方法。 本標準適用于以電熱元件或電磁感應方式加熱，額定功率不大于 2000W、額定容積不超過 10L、額定蒸煮壓力為 40kPa～140kPa（表壓）的電壓力鍋
Minimum allowable values of energy efficiency and energy efficiency grades for electric pressure cookers
This standard describes the recommended proof testing of temperature regulators with ratings up to a maximum of 1500 psi (10350 kPa) at 100°F
Standard for Proof of Pressure Ratings for Temperature Regulators
