共找到 150 條與 校準檢查 相關的標準，共 10 頁
Guide to the Selection, Care, Calibration and Checking of Measuring Instruments in Industry Part 2: Simple Length and Angle Measuring Instruments
This Handbook is written for the users of simple length and angle measuring equipment in industry. A number of commonly used instruments are discussed
A guide to the selection, care, calibration and checking of measuring instruments in industry, Part 2: Simple length and angle measuring instruments
(a) Research institutions that conduct USDA-funded extramural research must promptly notify the ARIO should the institution become aware during
Grants and agreements. Part422:Research institutions conducting usda-funded extramural research; research misconducts. Section422.7:Notification of ARIO during an inquiry or investigation.
Photometers. Determination of metrological characteristics, classification according to the latter, calibration, check of the main characteristics liable to vary with time.
Cross References: IEC 60645-4:1994 EN ISO 389-2:1996*ISO 389-1*ISO 389-2:1994*IEC 60318-1:1998*IEC 60318-2:1998 *IEC 60645-1*IEC 60711
Acoustics. Reference zero for the calibration of audiometric equipment-Reference equivalent threshold sound pressure levels for pure tones in the frequency range 8 kHz to 16 kHz
Reference equivalent threshold sound pressure levels for earphones, complying with stated requirements
Acoustics. Reference zero for the calibration of audiometric equipment-Specification for a standard reference zero using an artificial ear complying with BS 4669
This guideline describes an experimental method for determining the measurement uncertainty of task-specific contour measurements using standards
Accuracy of contour-measuring systems - Characteristics and their checking - Determination of the uncertainty of specific contour measurements using standards/calibrated workpieces
Method for checking, at any time, the stated concentrations of the gaseous calibration constituents of all calibration gas mixtures stored
Methods for preparation of calibration gas mixtures. Comparison methods and methods for establishing traceability-Checking by a comparison method
Stabilisce le prescrizioni ed i metodi di prova particolari per i controlli periodici di taratura e di corretto funzionamento della strumentazione
Installed contamination meters and monitors for measuring hands and feet alpha, beta and gamma surface contamination. Calibration and performance routine tests.
Accuracy of contour-measuring systems - Characteristics and their checking - Determination of the uncertainty of specific contour measurements using standards/calibrated workpieces
(a) USDA reserves the right to conduct its own inquiry, investigation, and adjudication into allegations of research misconduct at a research
Grants and agreements. Part422:Research institutions conducting usda-funded extramural research; research misconducts. Section422.5:Reservation of right to conduct subsequent inquiry, investigation, and adjudication.
SAME AS ISO 389-8
Acoustics - Reference zero for the calibration of audiometric equipment - Part 8: Reference equivalent threshold sound pressure levels for pure tones and circumaural earphones
La presente norma è la versione ufficiale in lingua inglese della norma europea EN ISO 389-5 (edizione novembre 1999). La norma specifica i
Acoustics - Reference zero for the calibration of audiometric equipment - Reference equivalent threshold sound pressure levels for pure tones in the frequency range 8 kHz to 16 kHz
1.1 This practice provides guidelines for calibration and instrumentation (both analog and computerized systems) used in the psychophysiological
Standard Practice for Calibration and Functionality Checks Used in Forensic Psychophysiological Detection of Deception (Polygraph) Examinations
Calibration of measuring instruments for electrical quantities Test equipment for checking the safety of electrical equipment Electrical equipment according to DIN VDE 0701 and DIN VDE 0702
