共找到 150 條與 火點 相關的標準，共 10 頁
PYROTECHNIC FIRST FIRE COMPOSITIONS
Diese Flu?diagramme dienen: — Als Checkliste für die Durchleuchtung bestehender sowie — als Arbeitsanleitung für die Planung neuer
Maintenance of Physical Assets Flow-charts for procedure organisation
Petroleum products. Determination of flash and fire points. Cleveland open cup method (ISO 2592: 1973)
本標準規定了粒狀活性炭在流動空氣中參考著火點的測定。 本標準試驗方法測定的著火點并非活性炭在具體用途的操作條件下可能發生的著火點。 本標準適用于木質、煤質粒狀活性炭。 本標準無意指明與活性炭使用有關的可能有的所有安全問題
Test method for ignition temperature of activated carbon
Fire ignition equipment. For gas equipment
Light pipe 40W ignition ignition, U-shaped light pipe
A presente Norma destina-se a estabelecer uma classifica??o de líquidos com base nos respectivos pontos de inflama??o
Fire Safety. Water source classification at fire point
1.1 This specification describes a high fire-point mineral oil based insulating fluid, for use as a dielectric and cooling medium in new and existing
Standard Specification for High Fire-Point Mineral Electrical Insulating Oils
Determination of Fire Point of Pyrotechnic Composition by Air Bath Method
本標準規定了用彎梁法測定玻璃退火點和應變點的試驗方法。 本標準適用于所有批量生產的玻璃，在樣品制備和試驗過程中玻璃不能發生失透現象
Determination of annealing point and strain point for glass
本標準規定以克氏開口杯測定石油類產品閃點及著火點之方法，但不適用于燃料油及開口杯閃點在 79℃（175℉）以下的油料。備考 1：本標準系采用公制單位為基準，所列英制單位，，僅供作參考。備考 2：本標準可作為測試及描述在可控制的試驗室條件下，材料、產品或組件對熱及火
Method of Test for Flash and Fire Points by Cleveland Open Cup
Quartz glass annealing point test method (drawing method)
Classification of insulating liquids according to fire-point and net calorific value (IEC 61100:1992); German version EN 61100:1992
Classification of Insulating Liquids According to Fire Point and Net Calorific Value
Test method for annealing point and strain point of glass
