共找到 150 條與 磨損損失 相關(guān)的標(biāo)準(zhǔn)，共 10 頁(yè)
This test method describes the procedure for determining the percent abrasion loss of asphalt mixture specimens using the Los Angeles abrasion
Standard Method of Test for Abrasion Loss of Asphalt Mixture Specimens
Standard Method of Test for Determining the Abrasion Loss of Asphalt Mixture Specimens
This test method describes the procedure for determining the percent abrasion loss of asphalt mixture specimens using the Los Angeles abrasion
Standard Method of Test for Determining the Abrasion Loss of Asphalt Mixture Specimens
Cross References: ISO 648:1977 ISO 3696:1987 ISO 6370-1:1991 FEPA 43-GB-1984 ISO 683-17:1976 ISO 2723:1973 ISO 2724:1973
Vitreous and porcelain enamels. Determination of the resistance to abrasion-Loss in mass after sub-surface abrasion
Vitreous and porcelain enamels. Determination of the resistance to abrasion. Loss in mass after sub-surface abrasion
Vitreous and porcelain enamels. Determination of the resistance to abrasion. Loss in mass after sub-surface abrasion
1???Scope This document specifies a test method for determining the resistance of vitreous and porcelain enamel coatings to abrasion by rubbing
Vitreous and porcelain enamels. Determination of the resistance to abrasion - Loss in mass after sub-surface abrasion
Loss Prevention VdS Loss Key
Vitreous and porcelain enamels - Determination of the resistance to abrasion - Part 2: Loss in mass after sub-surface abrasion (ISO 6370-2:2020)
Specifies a test method for determining the resistance of enamel coats to abrasion by rubbing, grinding or other mechanical effects. Annexes A, B
Vitreous and porcelain enamels; determination of the resistance to abrasion; part 2: loss in mass after sub-surface abrasion
This document specifies a test method for determining the resistance of vitreous and porcelain enamel coatings to abrasion by rubbing, grinding
Vitreous and porcelain enamels - Determination of the resistance to abrasion - Part 2: Loss in mass after sub-surface abrasion (ISO 6370-2:2020)
"This standard provides nomenclature for general modes of gear tooth wear and failure. It classifies@ identifies@ and describes the most common types
Appearance of Gear Teeth - Terminology of Wear and Failure
Vitreous and porcelain enamels – Determination of the resistance to abrasion – Part 2: Loss in mass after sub-surface abrasion
Appearance of Gear Teeth - Terminology of Wear and Failure
Vitreous and porcelain enamels - Determination of the resistance to abrasion - Part 2 : loss in mass after sub-surface abrasion
