共找到 150 條與 空包 相關的標準,共 10 頁
This notice should be filed in front of MIL-C-60616C(AR) dated 4 May 1990
CARTRIDGE, 5.56MM, BLANK: M200
This Amendment forms a part of Military Specification MILC- 60616C(AR), dated 04 May 1990, and is approved for use by the U.S. Army Armament, Research
CARTRIDGE, 5.56MM, BLANK: M200
This specification covers the 5.56mm Blank, M200 Cartridge for use in 5.56mm weapons for saluting andtraining
CARTRIDGE, 5.56MM, BLANK: M200
MIL-C-63267(AR), dated 13 July 1984, has been reviewed and determined to be valid for use in acquisition
CASE, CARTRIDGE, BLANK 105MM, M15B2
This specification is approved for use within the U.S. Army Armament Munitions and Chemical Command, and is available for use by all Departments
FIRING ATTACHMENT, BLANK AMMO: M20
This specification is approved for use by all Departments and Agencies of the Department of Defense
CASE, CARTRIDGE, BLANK 75MM, M9A1B1
This amendment forms a part of Military Specification MIL-C-70455(AR), dated 13 July 1984, and is approved for use by the U.S. Army Armaments
CASE, CARTRIDGE, BLANK 75MM, M9A1B1
This notice should be filed in front of MIL-F-63337(AR), dated 19 October 1979
FIRING ATTACHMENT, BLANK AMMUNITION: M19
This specification is approved for use by all Departments and Agencies of the Department of Defense
CASE, CARTRIDGE, BLANK 105MM, M15B2
Amendment 1 added the Salt Spray Test on the Chamber
FIRING ATTACHMENT, BLANK AMMUNITION: M19
This notice should be filed in front MIL-C-70455(AR), dated 13 July 1984
CASE, CARTRIDGE, BLANK 75MM, M9A1B1
This specification contains requirements not covered by the drawings, and provides quality assurance provisions for the fabrication of ports
FIRING ATTACHMENT, BLANK AMMUNITION: M19
本規程規定了蘭州百合的質量分級、技術要求、試驗方法、檢驗規則和標志、包裝、運輸、貯存。本規程適用于經精選、保鮮加工、真空包裝的蘭州百合(鱗莖和鱗片
Vacuum Packaging Lanzhou Lily
This specification covers the requirements and verification methods for the Cartridge, Blank, Caliber.50, M1A1
DETAIL SPECIFICATION CARTRIDGE, CALIBER.50, BLANK, M1A1
本標準規定了外抽式真空包裝機的術語和定義、型號、型式、基本參數及工作條件、技術要求、試驗方法、檢驗規則、標志、包裝、運輸和貯存。 本標準適用于采用塑料、復合薄膜等作為包裝袋,在包裝袋開口處插入抽氣管,通過一定(某種)控制方式抽真空,當抽氣時間達到設定值后對包裝袋進行熱封的真空包裝機(以下簡稱包裝機
External vacuum packaging machine
Copyright ?2007-2025 ANTPEDIA, All Rights Reserved
京ICP備07018254號 京公網安備1101085018 電信與信息服務業務經營許可證:京ICP證110310號
頁面更新時間: 2025-07-11 16:34