共找到 150 條與 空氣動力學(xué)直徑 相關(guān)的標(biāo)準，共 10 頁
Terms used for direct current electric transit overhead contact systems are defined in this standard
IEEE Draft Recommended Practice for Terminology Used for Direct Current Electric Transit Overhead Contact Systems
This standard is concerned with the method of testing the tightness of hollow bodies of various shapes to a specified internal test pressure without
Hydraulic pressure test for hollow bodies of various shapes up to a specified internal pressure.
CNCL S/S BY AGMA 911
Design Procedure for Aircraft Engine and Power Take-Off Spur and Helical Gears
W/D NO S/S
Information Sheet Gear Scoring Design Guide for Aerospace Spur and Helical Power Gears
La présente norme fixe les gammes norma-lisées des alésages des vérins et des diamètres des tiges de piston. Elle fixe également les dimensions de
Water and air transmission. Top pump chamber. Piston rod diameter and orifice size
Statistical simulation algorithm for naval gun weapon system shooting effectiveness evaluation on air target shooting effectiveness index (direct hit)
Power transformator Part 3.1: Insulation level and dielectric test external clearances in air
Hydraulic pressure test for hollow bodies of various shapes up to a specified internal pressure.
Information pipe pressure gauge, template for measuring vacuum meters in nominal diameters of (80, 100, 150, (200) and 340 mm)
Naval gun weapon system shooting effectiveness assessment method for air target shooting assessment (direct hit)
Test method for evaluating the firing effectiveness of naval gun weapon systems against aerial targets (direct hit)
Aviation equipment. Hydraulic systems. Pass-through and transitional connectors, under axial pressure fitting for pressure 35 MPa. Angle connector, coupling - nipple with nut
Railway transport equipment. Tank cars of the "hydrochloric acid" type. Pressure-evacuated filling caps with a diameter of 50 mm and 80 mm.
Esempio e prospetto con designazione. Motore elettrico: vedere unel 13113-71 a unel 13122-69
Oil hydraulic equipment. Hydraulic power units with electric motor, vertically mounted. Sizes and dimensions.
This standard specifies the method of determination of the ultimate tensile strength, tensile modulusand, if required,The Poisson's ratio
Aerospace series - Carbon fibre reinforced plastics - Unidirectional laminates - Tensile test perpendicular to the fibre direction
