共找到 150 條與 誤差指數 相關的標準，共 10 頁
Travel risk management - Guidance for organizations (ISO 31030:2021); Text in German and English / Note: Date of issue 2023-06-16
Civil engineering drawings - Indication of limit deviations
TRUNCATED CONE ABRASIVE SLEEVES. DESIGNATION. DIMENSIONS. TOLERANCES.
Hands for watches; upper and lower deviations for holes and shaftsAiguilles pour montres; diamètre d'ajustement, écarts inférieurs et superieurs pour
Hands for watches; upper and lower deviations for holes and shafts
? ??? ?? ?? 1700km/h ? 1000kt??? ??? ??? ??? ??? ?
Table of differential pressure for airspeed indicators
TRUNCATED CONE ABRASIVE SLEEVES. DESIGNATION. DIMENSIONS. TOLERANCES.
Travel risk management - Guidance for organizations (ISO 31030:2021); Text in German and English
The standard specifies the principle of the relationship between dimensional (linear and angular) tolerances and geometrical tolerances
Teknisk tegning. Grundprincipper for tolerancerangivelse
Riguarda la selezione di zone di tolleranza per accoppiamenti raccomandati ed ha lo scopo di limitare il numero di utensili, calibrati di verifica e
ISO system of limits and fits. Selection of tolerance zones for recommended fits.
1 Denne tekniske rapport kan anvendes som en vejledning ved verifikation af geometriske tolerancer, som er defineret i DS/ISO 1101. Form?let er
Geometricai tolerances — Verification principles and methods for tolerances of form, orientation, location and runout — Guidelines
Guidelines for the establishment and application of tolerance and connection systems, dimensional and form tolerances
This standard gives guidance in case of complaints when a colour deviation is observed after installation of a textile floor covering by the installer
Textile floor coverings - Guidelines for acceptable colour deviations
Sawn timber used in pallets - Permitted deviations and guidelines for dimensions
Guiding principles for the establishment and application of tolerance and connection systems. average value of tolerance size
Si riferisce alle tolleranze dimensionali ed ai relativi sovrammetalli di lavorazione dei getti di ghisa (vedere UNI 5007 e UNI 5330), colati in forme
Unalloyed grey iron sand castings. Deviations in dimensions without tolerance indication and machining allowances.
