共找到 150 條與 邵爾A型硬度計 相關的標準，共 10 頁
本標準規定了邵爾硬度計法測定膠輥表觀硬度的試驗條件、儀器及試驗步驟等。 本標準適用于在硫化膠輥上測定邵爾硬度、主要用于中級精度要求的測定
Determination of Apparent Hardness of Cots by Shore Hardness Tester
Verification Regulation of Shore A Durometers
本標準規定了邵爾A型橡膠硬度計（以下簡稱硬度計）的結構尺寸、要求、試驗方法、檢驗規則和標志、包裝、運輸及貯存等。 本標準適用于測定硫化橡膠、塑料及熱塑性彈性體等硬度的硬度計
Technical specifications for rubber durometers types A
General silicone rubber compound (Shore A type hardness 45~55)
Specifications for Shore A Pocket Rubber Hardness Tester
General purpose silicone rubber compound (Shore A type hardness 65~75)
Настоящий стандарт распространяется на резину и резиновые изделия и устанавливает метод определения их твердости от 0 до 100
Rubber. Method for the determination of Shore A hardness
General purpose silicone rubber compound (Shore A type hardness 55~65)
General purpose silicone rubber compound (Shore A type hardness 35~45)
High-strength silicone rubber material specification Shore A hardness 45~55,55~65
本規范適用于制造在 -65~+205°C 溫度范圍內、耐天候老化、石油基潤滑油或在電場中工作的模壓制品和壓出制品。本規范不適用于制造接觸汽油、芳香族燃油和低苯膠點石油基液體的制品
Specification for general silicone rubber coating (Shore A type hardness 75~85)
本規程適用于 D 型邵氏硬度計首次檢定、后續檢定和使用中檢驗
Verification Regulation of Shore D Durometer
本規范適用于AO型邵氏硬度計的校準
Calibration Specification for Shore AO Durometers
Shore hardness tester
Shaopuer hardness test
