共找到 150 條與 邵爾A型硬度計 相關的標準，共 10 頁
The Determination of Indentation Hardness by Means of a Durometer (Shore A and D) (English/German; This standard may be applied only for current projects. It is Superceded for all global future projects and replaced by ISO 7619-1 and ISO 868.)
Thermoplastic Elastomer - Styrene Block Copolymer, Shore A85, Interior/Exterior
ELASTOMER – THERMOPLASTIC - STYRENIC TYPE SEBS, 87 SHORE A
Thermoplastic Elastomer - Styrenic Block Copolymer, Shore A90, Interior/Exterior
Elastomer: Silicone, Rubber (MQ/VMQ) General Purpose 65 – 75 Durometer Type ‘A’ Hardness
Elastomer - Thermoplastic - Styrenic Type SEBS, 75 Shore A
Thermoplastic Elastomer, Styrenic Type SEBS, 87 Shore A
Thermoplastic Elastomer, Styrenic Type SEBS, 90 Shore A
Thermoplastic Elastomer, Styrenic Type SEBS, 70 Shore A
Thermoplastic Elastomer, Styrenic Type SEBS, 43 Shore A
Elastomer: Silicone Rubber (MQ/VMQ), General Purpose 45 - 55 Durometer Type “A” Hardness
PVC - 85 Type A Durometer, Heat Stabilized, Flexible, Extrusion Molding Compound
5.1 This method is based on the penetration
Standard Test Method for Type A Durometer Hardness Testing of Road Marking Thermoplastic at Elevated Temperatures
POLYVINYL CHLORIDE (PVC), FLEXIBLE, 55 A DUROMETER HARDNESS, INTERIOR ***TO BE USED WITH FORD WSS-M99P1111-A***
1.1 These requirements cover straight conduit and coilable, smooth-wall, continuous length conduit with a circular cross section: a) Extruded straight
UL Standard for Safety Type EB and A Rigid PVC Conduit and HDPE Conduit
